sandstone wall cladding and wall panelling for interior and exterio, column cladding and application also for column casing

The wall and floor panel

The Sandstone light wall/floor panel was developed for basic interior construction. It can be processed easily by anyone and can be glued into place almost anywhere with conventional natural stone - and is even easier than putting down floor or wall tiles.

Base material: none
Standard measurements: 600 x 300 x 2,5 mm
Weight: ca. 4500 g/m²
Surface: standard sealing, water repellent by request

Laying tips / laying instructions

* Sub floors must be solid and dust free
* Divide the dispersion adhesive evenly with a B2 toothed spatula (2,9mm teeth) (only use the amount you will process in one hour)
* Apply the first wall board aligned and level and firmly press down the board with your hands
* Place the following boards in a butt joint bond
* Avoid coming out of adhesive, gut immediately if it does
* Turn the board around for cutting, carve with the cutter and break it (carve through with cutter for holes)

* For edge formation heat the protrusion with a hot air gun and press firmly
(remove fissures in edges with heat and a wooden wedge)
* For a bricked appearance, straighten the joints with heat and a wooden wedge
* Close the X-el with YTTER special silicone